Home>Sports Flooring Installation Steps

Sports Flooring Installation Steps

Edit: Denny 2020-03-26

As a common ground decoration engineering material, sports flooring has the advantages of wide management range, good stability, wear resistance and easy maintenance. It is widely favored by professionals of sports teachers. Do you know how to install sports flooring? Here are the steps for installing the sports floor in the gym.

Sports reinforced floor installation method



There are two ways to use reinforced flooring for mobile installation and fixed installation. Exercise can strengthen the floor before installation. Students are required to lay the ground flat and clean. Before laying the PVC plastic sports floor, you must learn to unroll it in advance for more than 24 hours, and the ambient temperature on site should not be lower than 15 ° C. Arrange the floor in the order of continuous strengthening of the floor, align and merge, and pay attention to yourself. Athletic ability Align the field line during the laminate flooring process.

Gym wooden floor installation steps

1. The personnel laying the ground must be level and clean.

2. Before laying the PVC plastic sports floor, it must be laid for more than 24 hours in advance, and the temperature on site should not be lower than 15 ℃. After the floor is reduced, the cutting ends should be kept 5 cm. Before pasting, the unfolded floor can be rolled up by about half in reverse direction, and then the glue is laid-starting from the intermediate business-the toothed scraper for glue cannot be used for analysis and construction.

3. Arrange the floor in numerical order and combine the alignment to align the note field lines during the paving process.

4. Open the two adjacent Chinese floors along the joint, place the special network connection belt provided by the manufacturer on the lower side of the joint, and brush the surface of the joint belt.

Firstly, one of the learning board is used to stick half of the student as the connection band, and then the other half is attached to the remaining connection enterprise band, and the gap can be tightly closed.

5. It is recommended to use harmless water-soluble glue for construction. When extruding wood floor with a soft paste, the floor surface from the middle to the two ends will not be left to form any bubbles, and it will be completely flattened.